1.Setup your daylighting mode (Room Settings)
2.Create the daylight harvesting zone by adding the photocell(s) and lighting control loads to the zone
3.Set your lighting level to the approximate target light level for the space
4.Go to the photocell configuration from the devices page, adjust the maximum calibration level until the reported value is approximately 50% (128 on a scale of 0-255)
5.DO NOT PROCEED until step #4 is complete. Everything that follows will not be possible until step #4 is complete
6.If you haven't already, place a light meter at a representative task location
7.Go to the daylight harvesting zone
8.Use the target adjustment control to increase or decrease the lighting level until the light meter reads the appropriate lighting level
9.Press the save button
