0 Replies Latest reply: May 23, 2012 7:59 PM by Roberto Cadena RSS

Having trouble with VRCS2

Newbie

Hi, I am having trouble configuring the VRCS2 double control. I follow the programming procedure in order to include it into the remote control VRCPG following the regular procedure:

1. Pressing both buttons in order to get it into the programming mode

2. Including the node into the remote control

3. Naming the device in the remote control

4. Pressing enter to save the changes in the control

 

Once I complete the procedure, the device does not follow the remote control orders, and it does not even react when I press either of the device buttons in order to start the lights I connected to it.

 

At that point, I have to reset the device completely, pressing both buttons again for more than 10 seconds in order to clear the device memory and have it operating again manually.

 

Any suggestions?

 

Thanks!