I have a 50 node all Leviton Vizia RF network in my home. I also have an HAI omnipro II panel. I set up the network with a RZCPG-BSG remote because I didn't require the remote to manage events. The remote died a year or so ago and it wasn't an issue as all was working well. I decided to add a Kwikset deadbolt with z wave radio and found that I needed to upgrade my serial adapter to the +3 model and upgrade the firmware on my Omnipro. Because the remote was no longer available to hand off primary control to the also included installer tool, I defaulted each node and included them into the new network. The resulting network will respond to commands from the installer tool and the Omnipro panel and the dead bolt reports back it's state when manually locked or unlocked, but all of the lighting and fan nodes will not send status reports to the installer tool or to the serial adapter. I have tried everything I can think of to get the 2 way working but I have not succeded yet. Does anyone have any suggestions regarding where I have failed? Any input would be greatly appreciated.

Thanks, Jon