• Toggling an ALC Dimmer From a 4-Button Scene Switch

    Situation:   An ALC four button scene switch is installed as Unit 1.   A dimmer switch is installed as Unit 2.   Desired Effect:   Use Button 1 on the scene switch to turn Unit 2 on an...
    Ernie Sieber
    last modified by Ernie Sieber
  • How do I reset the code on a Legacy Model 1503?

    Question:   How do I reset the code in a 1503?   Answer:   To reset the code in a 1503 system:   At the processor (located inside the controller, on the door), press the Reset Button....
    Ernie Sieber
    last modified by Ernie Sieber
  • No Controller Data

    Display shows, "No Controller Data":   Is the Status light on the main panel flashing once per second?   If the Status light is not flashing once per second, power down the system (both A/C and batter...
    Ernie Sieber
    last modified by Ernie Sieber
  • Console Trouble Beeps

    Three beeps from the console are audible only on three occasions:   When you press an invalid key on the console. When there is a momentary loss of communication on the data bus. Theconsole has been commande...
    Ernie Sieber
    last modified by Ernie Sieber
  • Calibrating the 14A00-8 Water Temperature Sensor and 1101A PESM

    The temperature can be calibrated by using the potentiometer on the device. Turn the potentiometer clockwise to "lower" the temperature. Turn the potentiometer counter-clockwise to "raise" the temperature.   T...
    Ernie Sieber
    last modified by Ernie Sieber
  • 41290-HD* protrusion

    How far in front of the plastic insert does the HDMI connector protrude in this insert?
    Darby
    last modified by Darby
  • ODD / EVEN DAY PROGRAMS

    Occasionally, a customer has a need to run programming on specific days of the week.  One example might be to run a lawn watering routine, but only on “odd” days.  With a little programming using...
    Ernie Sieber
    last modified by Ernie Sieber
  • General ALC Wiring Precautions

    ALC Switch Modules are sensitive to electrical noise that may be caused by motorized devices, certain fluorescent lights, and other products that present an inductive load.   This electrical noise may be coupl...
    Ernie Sieber
    last modified by Ernie Sieber
  • Switched PDU Monitoring?

    Using SH081-1D1, what does the software program look like when it alerts the user of an issue?
    Darby
    last modified by Darby
  • Shielded copper trunk in DIN surface box?

    I need to bring a shielded Cat 6 copper trunk in to the 41089-6DN. Will this work?
    Darby
    last modified by Darby
  • 110-RJ45 Patch cords?

    Do you offer 110-RJ45 patch cords for your Cat 6 or Cat 6A 110 blocks, for testing?
    Darby
    last modified by Darby
  • Are Leviton category rated patch cords made of solid or stranded conductor cable?

    Leviton category rated patch cords are made from stranded cable, as patch cords ordinarily require more flexibility.  This is typical throughout the industry. ETL testing showins that the patch cords are componen...
    last modified by J89
  • Duraport cables and housings - outdoor use?

    Can we use the Duraport solution in an area outdoors, near a beach, that will be open to weather/rain/sand, etc?
    Darby
    last modified by Darby
  • What is the ST Fastcure Connector made from

    What type of metal is used on the barrel?
    Darby
    last modified by Darby
  • X-10 Problems

    X-10 responds slow when executing a macro (button):   Look at the TX-523 Interface when an X-10 signal is being sent. Does the LED on the TW-523 blink (solid off – solid on) or does the LED dim and brigh...
    Ernie Sieber
    last modified by Ernie Sieber
  • Built in/10A17 Serial Interface Board Problems

    This article was created to assist in troubleshooting serial interface problems within both the 10A17 Serial Interface Module, as well as the built in Serial Port on the OmniLT, OmniII, OmniLTe, Lumina, Omni IIe, Lumi...
    Ernie Sieber
    last modified by Ernie Sieber
  • Patch panel wiring diagram needed

    I have two panels marked Leviton PWA 58159 - looks like at CAT5 patch panel, and PWA 58163 - distribution panel.   Cannot figure out how to connect in the phone, works fine for internet.   Wondering if any...
    last modified by Keith Smith
  • Launch Packet - NorthStar 0-10V Outdoor Lighting Control

    Anna Alexander
    last modified by Anna Alexander
  • Patch-cord Serial Number Recording?

    I notice that all of the fiber patch-cords used in our installation have a serial number.  Do I need to document/record all of the serial numbers to comply with ANSI/TIA standards?
    Mat Gallien
    last modified by Mat Gallien
  • "A" Wiring Standard

    Has Leviton considered offering an "A" only wiring standard for Cat 6 jacks.
    last modified by dmunson